Cisco路由器用xmodem快速安装IOS(一)

Cisco路由器用xmodem快速安装IOS(一),标签：电脑网络知识,网络基础知识,http://www.5ijcw.com

　　rommon 1 > confreg （ 输入“confreg”命令）

　　Configuration Summary

　　enabled are:

　　load rom after netboot fails

　　console baud: 115200

　　boot: image specified by the boot system commands

　　or default to: cisco2-C2600

　　do you wish to change the configuration? y/n [n]: y (选择 yes)

　　enable "diagnostic mode"? y/n [n]: n (选择 no)

　　enable "use net in IP bcast address"? y/n [n]: n (选择 no)

　　disable "load rom after netboot fails"? y/n [n]: n (选择 no)

　　enable "use all zero broadcast"? y/n [n]: n (选择 no)

　　enable "break/abort has effect"? y/n [n]: n (选择 no)

　　enable "ignore system config info"? y/n [n]: n (选择 no)

　　change console baud rate? y/n [n]: y (选择 yes)

　　enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400

　　4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200 [7]: 0 (选择 0,改回用标准速率速率9600的xmodem传输)

　　change the boot characteristics? y/n [n]: n (选择 no)

　　Configuration Summary

　　enabled are:

　　load rom after netboot fails

　　console baud: 9600

　　boot: image specified by the boot system commands

　　or default to: cisco2-C2600

　　do you wish to change the configuration? y/n [n]: n

　　You must reset or power cycle for new config to take effect

　　rommon 2 >

　　此时手工改回计算机串口与超级终端2者传输速率为9600

　　然后敲入

　　rommon 2 >reset

　　( 最好关电源)

上一页  [1] [2] 

上一篇：实现无线安全的三大途径和六大方法(一)